PPoE Username and password - used as variables in script

Discussion in 'Tomato Firmware' started by alienrex, Jul 29, 2010.

  1. alienrex

    alienrex LI Guru Member

    I would like to use username and password for PPoE in my script (in WAN-UP section). If i change password then i will change it only in one place and script will use always correct variable. How can i do it?
     
  2. rhester72

    rhester72 Network Guru Member

    `nvram get pppoe_passwd`

    Rodney
     
  3. alienrex

    alienrex LI Guru Member

    Thanks for pointing it to right direction.

    with nvram show i got parameters name for what i needed.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice