PPPoE Force Reconnect bug

Discussion in 'DD-WRT Firmware' started by The_Unknown, Jan 19, 2008.

  1. The_Unknown

    The_Unknown Network Guru Member

    Hi,

    On Setup Page, PPPoE setting:

    Force Reconnect only allows to change the hour, even if I change the minutes to something else and Save (or Apply), it still defaults the minutes to "00".

    Anyone else noticed this?
     
  2. zeco

    zeco Guest

    I had the same issue, on DD-WRT v24 RC-6 (01/02/08) vpn (SVN revision: 8743)

    If you check what was stored in /tmp/cron.d/pppoe_reconnect you'll see that dd-wrt actually did store the minute value correctly, so it's just a misrepresentation in the web interface.

    So this is still a bug since you can't check your exact setting. A temporary workaround would be to kill the pppd daemon using a separate cronjob:

    In the Administration -> Management Tab, add the following line to the "Additional Cron Jobs" inputfield:
    Code:
    37 4 * * * root killall pppd
    In this example pppd will be killed each day on 4:37am, prompting the dd-wrt to start it again immediately. Thus you'll have a immediate pppoe reconnect.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice