1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Problem while setting up NAS EFG120

Discussion in 'Networking Issues' started by capsmon, Jun 1, 2005.

  1. capsmon

    capsmon Network Guru Member

    Everything which is required on the physical connection is
    fulfilled,but i can't seem to detect the new EFG120 with the setup
    wizard.Do you have any idea bout it.

    Things were done include:
    1. NAS is directly connected to one of my thinkpad.
    2. NAS is powered up, the green light of 'ready/status' is on, green
    light for disk 1 and disk 2 are on without blink.
    3. I didn't reset the jumper on the two harddrives which i installed
    into the NAS as i just leaved the jumper as default.
    4. I have another NAS which is running on LAN,but i can detect it with
    the Setup wizard.It is listed on the selected drive panel,but when i
    connect the new NAS to the LAN,n click on search again,i can't see any
    new NAS on the selected drive panel.That's the problem i encountered.

    Hope i can get a favourable answer from the support team,thanks.
     

Share This Page