Problem with WRT54G after power outage?

Discussion in 'Cisco/Linksys Wireless Routers' started by adrian.g, Jan 2, 2008.

  1. adrian.g

    adrian.g Guest

    Hi everyone,
    Yesterday there was a small power outage, and after everything was running again, I couldn't connect to the internet. (Oh, and I hope I posted this in the right forum)

    After about 2 hours on the phone today with my ISP, they reset my modem remotely and everything was going OK, except that whenever I tried to use my router, it didn't work.

    After trying to do a hard reset a bunch of times, I must have done it correctly because my router management password and username reset to the DD-WRT defaults.

    The problem is that none of the LAN ports work so I'm unable to configure a password onto it. It is broadcasting a wireless signal and it allows me to configure the settings at 192.168.1.1, except for the wireless encryption.

    Here is a picture of the router LED's in case I am as bad as explaining as I think I am :wink:

    [​IMG]

    All of the ethernet LED's are on, as well as the internet (it's not connected to my router, though) LED.

    Well, those are as many details as I can think of. Any help would be appreciated! :) Thanks in advance!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice