Problems by using WRT54GL as Access Point

Discussion in 'Tomato Firmware' started by thomas, Apr 28, 2011.

  1. thomas

    thomas Networkin' Nut Member

    Hello Guys,

    i have some trouble by using 3 WRT54GL with tomato 1.28 as access points.
    each access point (AP) is in a different room of a large building. if i use a handheld with wlan connection and go from AP1 to AP2 i have seen a small delay because of the roaming i think. if i go from AP2 to AP3 i see the same little problem - but... if i go back from AP3 to AP1 the delay is around 20-25 seconds! i also checked the original linksys firmware and also changed the handheld devices for testing.

    did anyone ever used more than 2 WRT54GL as access point? Any special settings in the webinterface needed for the correct function? thanks in advance for every reply
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice