1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Problems with WDS+AP

Discussion in 'Tomato Firmware' started by cirilc, Nov 30, 2008.

  1. cirilc

    cirilc Addicted to LI Member

    Hi,

    I'm having problems with this configuration:

    Router 1: WRT54GL, Tomato 1.22.8010 Victek Mod; WDS+AP WPA-Personal TKIP
    Router 2: WRT54GL, Tomato 1.22.8010 Victek Mod; WDS+AP WPA-Personal TKIP

    Routers are in WDS. WDS is working great. Router 1 is connected to internet.

    The problem is, I cannot connect with any wirelles card or notebook or PDA on Router 1. I can see SSID, the signal is good but no connection. If I reset router then maybe in first minute I can connect to router. MAC filter is not active, because I have fresh flashed firmware. Interesting is, I could connect to Router 1 if I put a DD-WRT on it, but I need IP/MAC limiter (temporary not active).

    Any help will be apreciated..

    BR
    Cic
     
  2. AmyGrrl

    AmyGrrl LI Guru Member

    Try using AES.... I myself could not get it to work with TKIP

    My setup is almost the same... just different routers.... Router 1 is connected to the Internet... using the same firmware as you... been using this for about 4 months now... works great...

    Router 1: WRT54G v1.1, Tomato 1.22.8010 Victek Mod; WDS+AP WPA-Personal AES
    Router 2: WRT54GL v1.1, Tomato 1.22.8010 Victek Mod; WDS+AP WPA-Personal AES
     
  3. cirilc

    cirilc Addicted to LI Member

    Hm, It seems to work now (with AES). Funny thing, when I first change AES on both routers, WDS didn't work. Setting back to TKIP it starts to work and everything just worked (clients too). Then I set up AES again and it works like a charm... Will see what will be after a while...

    Thank you very much for your help...

    Ciril
     

Share This Page