problems with WRT54G v5 vxworks upgrade

Discussion in 'DD-WRT Firmware' started by robr, Aug 8, 2006.

  1. robr

    robr Network Guru Member

    Greetings, I'm following the wiki here
    http://www.bitsum.com/openwiking/owbase/ow.asp?WRT54G5_CFE

    to flash my WRT54G V5

    After the step that says to flash with vxworks_prep_v03.bin file, my browser "went blank" (actually said it couldn't connect) so I rebooted.

    The next step says to connect to the router again, but I can't ping it and the power light is flashing (it mentions that the power light will do this after the next step, but I can't get that far).

    I'm wondering what I can do at this point and why this might have happened (I'm almost positive I did not flash the wrong file in step 1, I double checked before clicking the icon, but I suppose anything is possible).
     
  2. speeddemon

    speeddemon LI Guru Member

    Oke i know the problem i have to a wrt54g v5 the 1st thing you must do is give you networkcard a static IP 192.168.1.10 and a static gateway : 192.168.1.1 this wil do it when you did this you can connect again and you wil get a manager so you can uploud the file use the rest of the wiki manual
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice