1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

PSUS4 'bricked'?

Discussion in 'Other Linksys Equipment' started by Aquila76, Mar 10, 2006.

  1. Aquila76

    Aquila76 Network Guru Member

    I just got a PSUS4 wired printserver / 4 port switch. It is connected to a WRT54GL (which is smoking fast, btw). My main PC is wired to the router. I cannot get the Setup Wizard program to recognize the device. The router sees it connected and gives an IP address; I can ping that IP address, too. At first I thought: No big deal, I'll just use the web interface. When I try to use that, it refuses to load. If I hit stop (in IE or FF), it gives a patially loaded web interface. I was able to get to the upgrade firmware section of the web interface, but it doesn't appear to upgrade anything. I lastly tried to tftp the .bin file over, but it timed out. Is there anything else I can try to get this working?

  2. Aquila76

    Aquila76 Network Guru Member

    Ends up being an issue with the nVidia firewall on my PC. The PSUS4 works fine with the HP laptop I have. Apparently, even if you specifically add the IP, ports, applications, etc. used by the PSUS4, the firewall corrupts the connection to it. :thumbdown:

Share This Page