1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

QOS classification help needed

Discussion in 'Tomato Firmware' started by RegisteredUser, Dec 29, 2010.

  1. RegisteredUser

    RegisteredUser Networkin' Nut Member

    With the original firmware classifications intact I added a new classification
    Src IP 192.168.1.8 (my internal PC's address)
    Class: Highest
    Any Protocol

    everything else is as it was.

    When I check "View Details"
    192.168.1.8 traffic is always high, or even some low and unclassified
    Shouldn't ALL 192.168.1.8 traffic be "Highest"?? am I missing something here? :confused:

    I've tried with MAC too, no difference
     
  2. RegisteredUser

    RegisteredUser Networkin' Nut Member

    I figured out I had to move my new classification up to the top of the list. I did not realize at first that the placement of the rule determines it's priority as well. By raising the classification to the top most, but not all of my traffic is now "highest" on this machine, some is "Lowest" for port 80 and I cannot figure out why. All data should be highest.
     

Share This Page