QoS in the WAG54Gv2 ,did anyone ever get it working ?

Discussion in 'Other Linksys Equipment' started by nerochiaro, Jun 30, 2005.

  1. nerochiaro

    nerochiaro Guest

    Hi, i have recently picked up a WAG54Gv2 and it seems like a nice piece of hardware.
    But I have problems with the QoS function... i can't seem to make it work at all.

    I just enable QoS and set a custom port with high priority, and then all the rest of the traffic slows down to a crawl and almost stops. And this happens _even if i don't actually have any traffic_ flowing on that prioritized port !

    Anyone else experienced this ? Is it just me, or QoS support on this device is basically broken ?

    Also, is there a way to configure more than 3 custom ports in the QoS settings page ? (and the same is valid for port forwarding and most other pages with a fixed number of configurable fields)

    Thanks in advance for any help you might give regarding this.
     
  2. hijglander

    hijglander Network Guru Member

    Hi,


    I use firmware 1.00.47 and when I give high priority to http traffic everything is fast until I use http, then everything slows down to about 50% of the normal speeds.

    I haven't tried to set a custom port, but QOS in 1.00.47 seems to be working fine.


    Greetz,

    Hijglander
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice