1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Question about the Wireless Ethernet Bridge mode

Discussion in 'Tomato Firmware' started by Ronux, Dec 25, 2008.

  1. Ronux

    Ronux Guest

    Hello,


    I've installed the lastest tomato firmware on my linksys WRT54GL.


    I want to use the router as a wifi client to give an internet access to computers who are wired to it...

    So i've selected the Wireless Ethernet Bridge mode...

    All works but i can't access to tomato web-configuration, all computers receive an IP from the AP where the linksys is connect to...

    I'm sorry for my english, and i can make a schematic if you want...


    Thanks

    Ron

    edit: schematic :)

    [​IMG]
     
    Ronux, Dec 25, 2008
    #1
  2. kspare

    kspare Computer Guy Staff Member Member

    You still have to give the WRT54GL an ip address.. you probably left it with a 192.168 address.
     
    kspare, Dec 25, 2008
    #2
  3. bripab007

    bripab007 Network Guru Member

    Well, you still want it to have a 192.168.2.x address, but, yes, you need to either figure out what it is or give it one manually.
     
    bripab007, Dec 26, 2008
    #3

Share This Page