Question: LTE 4G Modem Signal Strength Command

Discussion in 'Tomato Firmware' started by The Master, Mar 17, 2017.

  1. The Master

    The Master Network Guru Member

    Hello all,

    does somebody know the command to get this from telnet or ssh from the router?

    I Use Shibby 138 Version. At the Frist connect i got this Stats:

    Code:
    user.notice root: 4G MODEM Signal Strength: RSSI -59 dBm, RSRP -87 dBm, SINR 22.2 dB, RSRQ -6.5 dB
    Or a little Script to give back this Info every second or so?

    Thank you
     
  2. pomidor1

    pomidor1 Networkin' Nut Member

    Shibby said, "when combined LTE log you will see:

    Jan 1 1:01:18 unknown user.notice root: 4G MODEM Current Mode: LTE
    Jan 1 1:01:18 unknown user.notice root: 4G MODEM Signal Strength: RSSI -83 dBm, -104 dBm RSRP, SINR 4.2 dB and -5.5 dB RSRQ


    possible that in the future this information will go to the GUI.

    check the signal can also check the command:
    switch4g WAN2 signal

    Of course, instead of WAN2 enter the WAN where LTE is set. Output to see the log. "
     
  3. The Master

    The Master Network Guru Member

    This does not work :(
    "switch4g WAN1 signal" and nothing in the log or onscreen :( tried all Wan/eth commands nothing :(
     
  4. Dobrinia

    Dobrinia New Member Member

    1)Add in Sheduller task:
    switch4g wan signal


    2)In log you see lines like:
    Code:
    Dec  8 10:45:00 XXX user info sched[32557]: Performing scheduled custom #1...
    Dec  8 10:45:02 XXX user notice root: 4G MODEM Current Mode: LTE
    Dec  8 10:45:02 XXX user notice root: 4G MODEM Signal Strength: RSSI -79 dBm, RSRP -107 dBm, SINR 10,2 dB, RSRQ  dB
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice