RAID 1 Problem

Discussion in 'Cisco/Linksys Network Storage Devices' started by estuardo4, Jan 13, 2009.

  1. estuardo4

    estuardo4 Addicted to LI Member

    Hello,

    I have a problem with my NAS 200, using firmware R75. I am using a RAID 1 system. I formatted the drives as EXT2. The problem is that I shot down the system, disconnected from the power source and took apart the HDDs to make some cleaning duties. I reinserted the drives, in the same order that I had and restarted the system. Now the web manager recognize the drives as a RAID 1 system, but I cannot access the drives. The system says:

    Volume Mode:
    Mirroring (RAID 1)
    Volume Status: RAID 1 - Not Ready
    Click following button to reset volume:

    Do not power-off the Network Storage System while reseting Volume Mode.


    Information
    Disk

    Model

    Status
    Disk 1 SAMSUNG HD103UI Used by RAID 1
    Disk 2 SAMSUNG HD103UI Used by RAID 1

    I don't want to touch the "Reset Mode" button, as I don't think it is a good idea.

    Is there a way that I can remount the RAID 1? Is my data toasted?

    I read about how flimsy this equipment is, but I never thought it would be that flimsy.

    I don't know much about Linux, but if there is a way to recover my data, please let me know.

    Thank you very much.

    GB
     
  2. estuardo4

    estuardo4 Addicted to LI Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice