Receive and Transmit rate fluctuating

Discussion in 'HyperWRT Firmware' started by mealto, May 24, 2006.

  1. mealto

    mealto LI Guru Member

    Just loaded Thibor15c. I am seeing that my Current Transmit Rate and Current Receive Rate fluctuate from 36Mbps, 48Mbps and 54Mbps. Should this be a concern? Tried various channels and still see this.
     
  2. lwf-

    lwf- Network Guru Member

    You could try to set the transmit power higher if the signal is bad. I run it at 53 mW (42 is the default value) as it is enough for my clients to get full signal/close to full signal.
     
  3. mealto

    mealto LI Guru Member

    Signal Strength is actually at -62dB or so. Isn't that pretty good? I am not too keen on increasing power if I don't have to. Just noticed that the Transmit and Receive speed fluctuates from time to time. Any more thoughts?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice