Regenerating Keys for JAC4 on NAS200

Discussion in 'Cisco/Linksys Network Storage Devices' started by SirLagz, Dec 11, 2014.

  1. SirLagz

    SirLagz Network Newbie Member

    Hi,

    I've inherited a NAS200, and first thing I did was to flash the JAC4 firmware onto it.
    However, it seemed to crash on first bootup after flashing it - I left it for a couple of hours and it still had not booted up - and now I cannot SSH onto the NAS200 - I keep getting "ssh_exchange_identification: read: Connection reset by peer"

    I'm assuming that the key generation probably did not complete. Is there a way I can make it regenerate the SSH keys without SSH ?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice