1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Remote admin

Discussion in 'HyperWRT Firmware' started by windage, Dec 25, 2006.

  1. windage

    windage Network Guru Member

    How do you turn it on in the telnet console? I couldn't seem to find the commands when searching. Thanks
     
  2. grcore

    grcore Network Guru Member

    Your subject says remote admin, but your question is about telnet.

    which is it?

    There is an issue (fix already applied, comin soon) for the gui for remote managment. (when you enable remote management, the gui still shows disabled even though it is enabled).

    As far as telnet goes, look further down the management page, you will see it.

    g
     
  3. windage

    windage Network Guru Member

    Sorry, my remote admin doesn't work at all. I have enabled telnet np. Just wanted to know how to enable remote admin from the command line.
    Thanks
     
  4. grcore

    grcore Network Guru Member

    nvram set remote_management=1
    nvram commit
    reboot
     
  5. windage

    windage Network Guru Member

    Thanks again
     

Share This Page