1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Remote reboot how ?

Discussion in 'Sveasoft Firmware' started by bax22, Apr 29, 2005.

  1. bax22

    bax22 Guest

    Hy everywhone!

    I use WRT54G (v.1.1) with Alchemy-pre7a v3.37.6.8 firmware.
    This router is used only for AP and is atached to another WRT54G with straight cable .
    This second is in wds mode with another WRT54G conected to my lan.
    Well everething with this wds part is work fine , problem is in this first WRT54G ... when I remote change few options it was somehow frozen , and now I cant connect with browser ...
    Now it is only respond to ping . On this WRT54G is disabled telnet and ssh.
    Is there any way to remote reboot this WRT54G ?
    It is on very hard accesable place ... on top of building ...18 floor .

    Thank for any tips !
     
  2. joebloggs

    joebloggs Network Guru Member

    You mean it's over in your neighbor's house and you can't get to it? J/K. No clue, although I did have to tell my neighbor to unplug the power to the router.
     
  3. littlewhoo

    littlewhoo Network Guru Member

    Telnet disabled, SSH disabled and remote management disabled?

    No, there is no way to access this router. Can't you just cut the power for a few seconds and wait until it reboots? Usually then the webinterface should be available again - except, you disabled the webinterface, too. :roll:

    If you can't access the connector of the router to cut the power, I guess you'll have to cut the power of the whole floor or the whole building. :D
     
  4. Guyfromhe

    Guyfromhe Network Guru Member

    not much you can do unless you have access to it some way...
    may want to look for a breaker for that outlet, and concider some type of remote power switch if this happens alot... or telnet into the thign before nmaking changes and see if it disconnects you, if it doesn't you can reboot it even if the web interface stops responding.
     

Share This Page