Remote Wake on Lan

Discussion in 'General Discussion' started by FireAndGlass, May 3, 2005.

  1. FireAndGlass

    FireAndGlass Guest

    I've been trying to setup a way to remote WOL my PC behind a WRT54GS for a bit but I am not finding much resources. I'm still quite the network newb (software dev but not much networking tinkering) and this site seems to be geared to the elite.

    All I really want is Remote wake on lan and static DHCP. Any recommendations on firmware (btw I have WRT54GS v2, as I know not much is available for that) Any resources or suggestions would be much appreciated, thanks.
  2. Guest

    Guest Guest

    Two dumb questions.
    1) What is static DHCP?
    2) Remote wake up on a router?
    Not sure what you mean.
  3. jagboy

    jagboy Network Guru Member

    1)staistic dhcp is when you assgin a computer a ip address like

    2)i think that FireAndGlass want to wake a comptuer on the network that is behind the router or attached to the router
  4. puffer

    puffer Network Guru Member

    I would just tell your router to give out dhcp addresses starting at and set your computers to , .3 , .4 and so on.. but if you really want sdhcp then I suppose you could get sveasoft's firmware version although I think they charge for it .. opps i mean for the support only and the means to download it.

    As far as Wake on Lan. If you go to they have something under tools that will forward the wake up packet to an ip address. Although I am not sure what port to forward for that. The problem with wake on lan is it seems to be geared towards local networks LAN not WAN. I think it might work off of some broadcast which the router will prevent. But I am really no expert on that. just my 2 cents.
  5. TazUk

    TazUk Network Guru Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice