resetting

Discussion in 'HyperWRT Firmware' started by MagicPinball, May 3, 2005.

  1. MagicPinball

    MagicPinball Network Guru Member

    Since rssi is a cumulative running average of signal strength, can it be reset with a command? (besides a reboot)

    I noticed that if I monitor the rssi from one router to the other, this value changes slightly. Or if I move the router if changes in value more. Obviously, this is expected. But, if I power down the extended router, the value on the monitored router stays the same. Or, is there another flag to tell if the connection exists?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice