Restore micro settings to standard version

Discussion in 'DD-WRT Firmware' started by jgkurz, Mar 28, 2007.

  1. jgkurz

    jgkurz LI Guru Member

    Hi Folks,

    I recently acquired a WRT54G v4 that I will be installing DD-WRT v23 SP2 on. I currently have a WRT54G v5 with DD-WRT v23 SP2 micro.

    Will I be able to save the settings from my V5 with micro and restore to my V4 with the full DD-WRT version? Sure would save a lot of work. :biggrin:

    Thank you.
     
  2. jgkurz

    jgkurz LI Guru Member

    I went ahead and restored the micro settings from my v5 to my new v4 with standard DD-WRT. The result was my settings transferred over properly to the v4 and the settings specific to the standard version just stayed at the default. I am amazed yet again at the quality of DD-WRT.
     
  3. ofbarea

    ofbarea Network Guru Member

    I was going to say that given that you use the same version of DD-WRT this should work and as the only difference between V4 and V5 is the quantity of memory. Glad it worked.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice