1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RFlow v3 Help

Discussion in 'DD-WRT Firmware' started by XCOM7, May 11, 2005.

  1. XCOM7

    XCOM7 Network Guru Member

    I am trying to monitor serveral router ins a remote location in the router I set the Static IP of my WAN and open the ports of RFlow in My router. The router gets info in from the remote router but the bandwith stay at 0.00 and it does not update... Aswell with the Computers in the network it does not register the systems...
    Is it possible to use RFlow to monitor Remote Routers?
    I am halfway there all I need to know is what I need to do to let the data from the remote to the RFlow register properly...
     
  2. XCOM7

    XCOM7 Network Guru Member

    Any body?
     
  3. oWeRp

    oWeRp Network Guru Member

    did u set up Rflow and macupdate to the right IP?
    works on 3 routers here.
     
  4. XCOM7

    XCOM7 Network Guru Member

    Yes I did.
    It seems to be working now its logging the bandwith of the remote routers but still no MACupd in. All I see are my local machines but not the remote ones....

    How did you have it config?
     
  5. XCOM7

    XCOM7 Network Guru Member

    Still looking for the info...
     
  6. oWeRp

    oWeRp Network Guru Member

    ports 2055 and 2056 are used for rflow and macupd,check that out.
    do u have multiple subnets?
     
  7. XCOM7

    XCOM7 Network Guru Member

    I have the ports correct everything is working fine I dont know why it was not working before..... It sorted started working by it self.... I have a question about the WLan Clients when I check "Only Online WLan Clients" it only shows the clients connected to My router whns I uncheck that it shows a bunch of clients and AP arround me .... That means that RFlow has survey built in to ity as well detecting whats arround me?
     

Share This Page