1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RIPv1 and v2?

Discussion in 'Tomato Firmware' started by jza80, May 28, 2009.

  1. jza80

    jza80 Network Guru Member

    Anyone happen to know how RIP works in Tomato?

    I see a setting for disabled, LAN, WAN, and both. Does this setting specify which network(s) are advertised through RIP? IOW if its set to LAN, only the LAN network is advertised.

    Does it only advertise routes using RIP or can it listen to?


    I'm used to the Cisco way of doing things were you enable RIP and specify the networks to advertise, so Tomato is a little strange to me. :p

Share This Page