Router-to-Router IPSEC tunnel - AG241 and Watchguard Firebox

Discussion in 'Networking Issues' started by Stu123, May 27, 2005.

  1. Stu123

    Stu123 Guest

    Hi,

    I'm trying to get a LAN-to-LAN IPSEC tunnel running between a Linksys AG241 and a Watchguard Firebox X1000. The tunnel is using isakmp, 3des, and have tried both SHA and MD5 authentication types.

    So far I have gotten the tunnel to connect, but it won't pass any traffic between the two subnets. Both ends have static IP addresses, the Watchguard's via a DSL line in bridge mode (i.e. Layer 3), and the AG241's is via PPPoA. LAN subnets are both /24 private address ranges. There doesn't seem to be any errors in the Watchguard's logs, just the usual connection messages for isakmp/ipsec, and the AG241's VPN logs are completely empty.

    Has anyone seen these symptoms before (even with different hardware) and has any suggestions for how to resolve this?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice