RV042 and Cisco VPN Client

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by swaggy, Dec 12, 2005.

  1. swaggy

    swaggy Network Guru Member

    I am trying to get a Client to Gateway tunnel to work on the RV042 to a Cisco VPN Client (4.6.01.0019). The RV042 is behind a cable modem and the Cisco VPN client is behind a NATed firewall.

    I configured a group on the RV042 side with DES/MD5 (I've tried 3DES/SHA1) w/ a Remote Client type of Email Address. On the Cisco VPN client side I am using IPSec over UDP (NAT/PAT) but I've also tried TCP port 10000. I used the group name configured on the router and the pre-shared key for the password. Either way, I can't connect and I am seeing the following error in the VPN log on the RV042:

    size (869) differs from size specified in ISAKMP HDR (853)

    What am I doing wrong?
     
  2. swaggy

    swaggy Network Guru Member

    So no one has been able to get the Cisco VPN Client to work with the RV0XX routers? I remember reading some posts here on this forum from a few people claiming that had it working.....
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice