1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Rv042 Ip Alias

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by juloy2003, Mar 22, 2007.

  1. juloy2003

    juloy2003 LI Guru Member

    Hi, I understand that the RV042 unit is configurable via telnet/ssh (BusyBox).
    In case, is it possible to setup an alias to ixp0 interface?, is usable the command ifconfig ixp0:0 xxx.xxx.xxx.xxx 0.0.0.0 for aliassing?
    I must buy a router. My ISP brings me 4 static public ip address, and I want to setup a web server in each, but my provider brings only one eth cable to connect.
    I really thank you for your help on this issue.
     
  2. juloy2003

    juloy2003 LI Guru Member

    Pardon my poor english.

    Excuses me, I've a very limited english -really poor-, maybe you can't understand my question. I guess...
    I'm unix systems administrator and I want to know if the RV042 model is capable of manage more than one public ip address with just one WAN active connection.
    If it's not possible, I want to know which model can I use?
     
  3. pablito

    pablito Network Guru Member

    Without delving too deep into the guts you would use "One to One NAT". If the RV042 doesn't have that then the RV082 & RV016 has it. You would associate each additional IP to an internat IP (your servers). It works very well although not as intuitive as a straight forward IP alias. Don't forget to build a set of firewall rules for them.
     
  4. Thibor

    Thibor Super Moderator Staff Member Member

    if you want to run a webserver on each, connect a 4 port switch to the dmz port and connect your 3 servers to that. then set the iprange option in the dmz setup. at least that's what i did and it works just fine.
     
  5. sbrochet

    sbrochet Guest

    Hello,

    I bought for the first time linksys products (i use to buy Cisco routers but i have a small project in this case and i think that linksys can perform in this case.). I bought 2 RV082.

    I need to configure 16 ip public adresses and want to "nat" connections relatively of public/port to private ip/port. Can i found a "Howto" somewhere ? Have somebody already written one ?

    I found here a document whose explain how to acess to RV082 by telnet.
    I need a "man" for all commands avaible in. Where can i found it ?

    Thanks for your future answer.

    Séb.
     
  6. juloy2003

    juloy2003 LI Guru Member

    Thankyou a lot. I will only use 3 ip address, each mapped to an private ip address. I want to attach a server to each external ip. I guess if I can use something like forward (ip/port) rule here.

    Thanks again.
    I will buy a RV042 device.
     

Share This Page