1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RV042 VPN issue

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by toddvin, Aug 29, 2006.

  1. toddvin

    toddvin LI Guru Member

    Hello all...1st time poster here and I am stumped...

    I am attempting to configure a tunnel from a Windows Pocket PC device using the BlueFire client (although I have the exact same problem with the Antha client) and here is what I am getting in the RV042 log:

    Aug 28 19:13:14 2006 VPN Log Ignoring Vendor ID payload Type = [XAUTH]
    Aug 28 19:13:14 2006 VPN Log Ignoring Vendor ID payload [4e61542d534982e0...]
    Aug 28 19:13:14 2006 VPN Log Received Vendor ID payload Type = [draft-ietf-ipsec-nat-t-ike-03]
    Aug 28 19:13:14 2006 VPN Log Ignoring Vendor ID payload Type = [draft-ietf-ipsec-nat-t-ike-02_n]
    Aug 28 19:13:14 2006 VPN Log Ignoring Vendor ID payload Type = [Cisco-Unity]
    Aug 28 19:13:14 2006 VPN Log [Tunnel Negotiation Info] <<< Responder Received Aggressive Mode 1st packet
    Aug 28 19:13:14 2006 VPN Log Initial Aggressive Mode message from 68.26.183.164 but no (wildcard) connection has been configured

    I ahve set up the Group tunnel on the 042 as follows:

    --Remote client = email address
    --dh group 5
    --des-md5
    --sa lifetime 28800
    --no PFS

    On the BlueFire client i have these options to set it up:
    --Name
    --IP
    --Group ID (wtf goes here? :))
    --password
    --username (I am assuming that these are for the various users that I have set up...right?)
    --then I have a checkmark for PFS which I left unchecked (it should be noted here that I did enable PFS on both ends and got the same errors).
    --Under this checkmark I have the IKE Key group drop down which I have set to DH5
    --The next screen has a checkmark for Nortel COntivity which is unchecked leaving the drop down beneath grayed out.

    That is it. When I attempt to connect I get the log entries above.

    Any help and guidance is GREATLY appreaciated!!! Im about to throw this darn little phone out the window....
     
  2. toddvin

    toddvin LI Guru Member

    I should also add that i worked on this extensively with the 1.3.7.4 firmware and then updated it to the 1.3.7.9 to no avial.

    I have been able to get a PPTP tunnel to connect from the phone but it is very unrelialbe.

    Thanks for any help
     
  3. jm23hh

    jm23hh Network Guru Member

    >>>
    Group ID (wtf goes here? )

    you need a Cisco VPN Concentrator or similar device to get this to work. Looks like the Bluefire is some kind of CIsco Software VPN Client for handhelds. this doesn't work with an RV042. You need compatible hardware for this. A Cisco VPN3000, a PIX or similar device.

    try another SW-Client with is compatible with less costly devices...

    jm
     
  4. toddvin

    toddvin LI Guru Member

    Does anyone know if there is a vpn client for pocket pc that works with the rv042?

    Thanks
     

Share This Page