RV082 Multiple WAN Subnets

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by guido331, Jul 2, 2013.

  1. guido331

    guido331 Network Guru Member

    Hi everyone,

    I have an RV082 (old blue and gray model) runnning I have a block of 5 static IPs from my ISP and have been using those with the One-To-One NAT function without issue. Basically one of my IPs is assigned to the WAN1 port and the rest are in use via the One-To-One NAT function. All that works fine.

    I have been given another static IP by my same host for another service I'm using and I'd like to use that IP with my RV082 also. The problem is the new IP is not consecutive with the original block that I already have. It's a completely different block and subnet.

    I had my provider plug a cable into the WAN2 port and assign the new static IP to that port. Then I assigned the new static IP on my end in the RV082. That didn't work like I wanted it to though. The new IP is not pingable (and I have WAN requests enabled) and I cannot access services on the other side of that IP via port forwarding.

    Any suggestions?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice