RV082: no NAT from subnets

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by pyroboy, May 17, 2005.

  1. pyroboy

    pyroboy Guest

    RV082 with firmware 1.1.6.11 (from Linksys support). Also tried 1.1.6.3.

    Packets from an internal subnet other than the subnet to which the RV082 is attached are not NATed.

    For example:

    RV082 at 192.168.1.1/24 (internal) and 220.220.220.220/24 (external and fake).

    Host1 at 192.168.1.10 contacts internet host. Packet source address at internet host is 220.220.220.220. GOOD! :)

    Host2 at 192.168.2.10 contacts internet host. Packet source address at internet host is 192.168.2.10. BAD! :(

    Linksys support say this is the expected behaviour.

    This is completely ridiculous. I don't think it's too much too expect that a business that requires 50 VPN connections may also have an internal subnet.

    I will be returning this unit.

    Does anyone know if any other Linksys gateway products suffer this limitation?

    Cheers...
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice