RV082 QuickVPN configuration note

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by russwmc, Mar 31, 2005.

  1. russwmc

    russwmc Network Guru Member

    I discovered on the lastest release of the firmware for the RV082, 1.1.6.3 that under the Firewall tab the Block WAN Request MUST be enabled for QuickVPN to function. I didn't see it listed anywhere else so I thought I would note it here.

    If you can ping your RV082 from the WAN side chances are your QuickVPN client is not connecting.

    This is NOT the case for the RV042 using firmware revision 1.3.6. It works fine with either Block WAN Request enabled or disabled.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice