RV082: separate two Subnets

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by ChristianF, Jun 14, 2010.

  1. ChristianF

    ChristianF Addicted to LI Member

    Hello everyone,

    I have a little problem and I don't know a way out. Here's the setup:

    There is a Cisco-Linksys RV082 router connected to a DSL line with some PCs on it. They run the 192.168.2.0 Network like 2.100, 2.101, 2.102 and so on. Internet access works great.
    Now here's the problem: there is a new device set up, it's a WLAN Hotspot device. I set up a second IP area inside the router named 192.168.254.0 where the router gets the 254.254 and the WLAN Hotspot Appliance gets the 254.100 (fixed IP Address). Now here's my problem: guest WLAN users (hotspot users) can access the PCs in the 2.0 subnet (for example, one of them runs an xampp and the pages can be seen). I looked for a thing to fix this, but don't have any idea... anyone of you?

    Thank you!
     
  2. venom51

    venom51 LI Guru Member

    You need a Deny all rule from 192.168.254.0 to 192.168.2.0

    then create a rule that allows traffic in both directions from 192.168.2.x interface of the router.

    That will isolate the 2 networks.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice