1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RVL200 and DNAT

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by elkong, Nov 22, 2010.

  1. elkong

    elkong Addicted to LI Member

    It seems the Port Forwarding under Setup doesn't let you change the port from the outside to the inside network.

    I'm trying to allow several PCs to be available from the outside via RDP. I could change the RDP port on each PC, but I was hoping to do it on the RVL200 router (f/w 1.1.12.1). So I wanted to assign different ports on the outside to different IPs on the inside on port 3389. Doesn't seem to be possible.

    The other option for me would be to use multiple public IP addresses that I have from the ISP, that doesn't seem to be an option either, I can't find a way to assign multiple IP addresses to the external interface.
    Is it just that this router is not really offering the features I expect from a Small Business router?
    Maybe the solution is to put it behind another router that handles those features and does a one-to-one NAT to the RVL200 to take care of the SSL VPN and the IPSEC.
     
  2. Toxic

    Toxic Administrator Staff Member

    could you not just use the builtin SSL Tunnel which will give you a local IP address then RDP to the PC via their internal IP addresses?
     
  3. elkong

    elkong Addicted to LI Member

    This is mostly for iPads, so that's not an option.
    I really like the SSL VPN, but I don't think it's a solution in this case.
    I was hoping to use this router to protect other services by using DNAT and multiple public IPs.

    By the way, it is inconvenient to have to use the 64-bit IE and Run as Administrator if your OS is Win7 64bit.
     

Share This Page