Greetings everyone! I'm having a bit of an issue with the RVL200. Everything works, but I seem to have a slight config issue somewhere. I have the RVL200 as my gateway from the cable modem to the rest of my network to allow eventual VPN access. My connection is as follows: Cable Modem --> RVL200 --> Dlink DIR-655 (acting as wireless access point). As I stated, everything is working (i.e. can get to internet from all systems). I have the RVL200 set up to act as the DHCP server for the network. I'm using firmware 184.108.40.206 (for Vista x64 support). Here's the curious piece. When I go into the RVL200 management GUI, and click the DHCP/Status tab, I see absolutely nothing under the Client Table. Shouldn't I see everything connected to the router?