RVL200 - Lock up when opening IPSec tunnel

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by Frank213, Dec 26, 2008.

  1. Frank213

    Frank213 Addicted to LI Member

    Hi all,

    I had an RVL200 running an IPSec tunnel against a Watchguard firewall which ran fine for months. As the Watchguard died I thought it was clever to replace it by an RVL200.
    But as soon as I set up the IPSec tunnel on the 2nd box and connect to the first RVL200 (or vice versa) one or both boxes completely lock up after 15-20 seconds.
    That means: Boxes run well, I enable IPSec, the tunel opens (I ping the opposite boxs internal IP), boxes lock up after 15-20 seconds.
    Boxes lock up means not accessible anymore from internal or external IP nor through the tunnel. Powering off and on solves it until the next IPSec tunnel is established.
    I also tried a 3rd box /w identical setup. My firmwares are 1.1.9.1 and 1.1.10.1.

    Have you got any idea why RVL200s do not work together and how to solve that?


    Thank you, Frank



    P.S. I tried different IPSec setups, the one I have now is:
    IP only - IP only
    IKE /w preshared key
    Group2
    3DES
    SHA1
    28800 s
    PFS
    Group2
    3DES
    SHA1
    28800 s
    Password: 30 chracters
    Compress
    Keep-Alive
    NetBIOS broadcast
    Dead Peer Detection (DPD) Interval 10 seconds
    NAT Traversal
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice