1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RVS4000 problem!

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by fredy1969, Jun 10, 2007.

  1. fredy1969

    fredy1969 LI Guru Member

    Hi;
    I've bought an RVS4000 and used it for a while. It worked correctly. Then I put it away for some changes made and now that I want to reuse it, it doesn't work! The green (power) and red (diag) LEDs blink alternately and the router did not boot; nor it respond to reset (on-time push) or factory setting (30-seconds push). It's obvious that it doesn't ping at all (it could not be known). I can not believe it is damaged! Please help me...
    (I have raised it in another forum. Sorry! I repeat it here for increase chance for reply!)
     
  2. tony4d

    tony4d LI Guru Member

    Call Linksys and get it replaced. I'm sure it will be under warranty, these haven't even been out a year yet have they?
     

Share This Page