RVS4000's not routing requests to tunnels when connecting w\ ClientVPN

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by raidu360, Sep 4, 2008.

  1. raidu360

    raidu360 Addicted to LI Member

    RVS4000 X3 in a mesh, gateway to gateway tunnels are all up, I can ping all sub-networks when plugged into any of the routers. When I IPSEC/VPN [using linksys QuickVPN or TheGreenBow] into any of the routers remotely I connect perfectly and I can ping all of the local devices but I cannot ping any of the sub-networks or [REMOTE DEVICES]...?

    Corp. Tech. Support is lost they don't even have a clue....?

    I thought maybe I was not getting the correct ip info but I get the same both locally and remotely.
    I thought maybe it was an IPv4/IPv6 issue, but it works connected locally so it should route remotely right...?

    Thanks for any thoughts.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice