1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SES LED Off after flashing Tomato firmware

Discussion in 'Tomato Firmware' started by jmmjm, Oct 12, 2008.

  1. jmmjm

    jmmjm Addicted to LI Member

    Hi,

    I am new to Tomato and I just flashed my new WRT54GL with the 1.21 Version. After that, I noticed the SES led was off, it was amber before.

    Could you tell me how to make the SES led back on? and Do i need to make a reset at the router end?

    Thanks in advance.
     
  2. Mastec

    Mastec Network Guru Member

    Log into your router

    Go to Administration

    Click on Buttons / LED
     
  3. jmmjm

    jmmjm Addicted to LI Member

    Thanks, there are two options there
    Amber SES
    White SES

    do i enable them both, or only one? and after that,
    do i need to manually reboot the router to make it into effect?

    thanks
     
  4. Mastec

    Mastec Network Guru Member

    Pick one or the other and then reboot.
     
  5. jmmjm

    jmmjm Addicted to LI Member

    Thanks a lot. The amber led is back on. I am curious with that what will happen if I pick Amber and White at the same time?
     
  6. Cynsick

    Cynsick Addicted to LI Member

    Is this about the only time you need to reboot the router? For changing this option or should you do it for others?
     
  7. Mastec

    Mastec Network Guru Member

    Scripts require a reboot as well.
     

Share This Page