1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

setting up network

Discussion in 'Cisco/Linksys Wireless Routers' started by lee8040, May 19, 2005.

  1. lee8040

    lee8040 Network Guru Member

    hi,

    ive just bought a wireless -g 2.4ghz broadband router WRT54G to connect to my ntl broadband net. i started to do what the cd instructed me to but when i get to the point where the pc starts to setup the routers settings it crashes and no matter how many times i try i cant get beyond this point.

    i have a linksys pci card on another pc which installed fine

    can anyone help me to install this router so i can connect it to my pci card?
     
  2. Morpheus

    Morpheus Network Guru Member

  3. lee8040

    lee8040 Network Guru Member

    the page is just blank when i click that link then it goes to a search engine
     
  4. Morpheus

    Morpheus Network Guru Member

    are you using a proxy? press the reset on the back of the WRT for 30sec and start again
     
  5. lee8040

    lee8040 Network Guru Member

  6. Morpheus

    Morpheus Network Guru Member

    Have you set the pc to receive the ip by DHCP?
     
  7. lee8040

    lee8040 Network Guru Member

    i cant even get the internet running through it, i have a patch lead from the modem to the router then another lead from the router to the pc but even through that the net wont connect i have to remove the cable from the router and plug straight into the pc
     
  8. lee8040

    lee8040 Network Guru Member

    no how do you do that?
     

Share This Page