1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Setting up PPTP getting 619 error with PPTP IP assigend to 0.0.0.0

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by Enze6997, Aug 23, 2006.

  1. Enze6997

    Enze6997 LI Guru Member

    Any ideas why PPTP isn't working? Do I need anything else past the Router for this to work? I thought the RV042 handled everything.

    I have the following setup....

    RV042 with Static IP on the internet, Firmware 1.3.7.9beta. Internal network is 10.40.1.x

    DHCP disabled.
    SNMP disabled.
    Firewall : Enable
    SPI (Stateful Packet Inspection) : Enable
    DoS (Denial of Service) : Enable
    Block WAN Request : Disable
    Remote Management : Enable
    Port: 8090
    HTTPS : Enable
    Multicast Pass Through : Enable
    MTU : Auto

    Access Rules are set to default
    Allow All Traffic [0] LAN Any Any Always
    Deny All Traffic [0] WAN Any Any Always
    Deny All Traffic [0] DMZ Any Any Always

    VPN
    I added a username for Client access that is enabled

    VPN Pass Through
    IPSec Pass Through : Enable
    PPTP Pass Through : Enable
    L2TP Pass Through : Enable

    PPTP Server: Enabled
    User created for connection.
    Range set for 10.x.x.200 to 204
     

Share This Page