Setting WRTG as AP, how can I access the UI? Find IP?

Discussion in 'Sveasoft Firmware' started by chunkee, Mar 6, 2006.

  1. chunkee

    chunkee Guest

    I have a prosafe Netgear with DHCP turned on. I have the WRTG with Alchemy setup as a AP with WPA and DHCP disabled. It is working fine, however, how can I find the IP of the WRTG now? Attached devices in the Netgear is not showing it up, I would like to be able to access the WRTG UI to make some changes. I have tried ARP, but that is not showing the Access Point.

    I am not a real guru at this and could use some pointers on how to make it easier to use it as an Accespoint and still be able to make changes to the configuration, such as adding MAC restrictions, and changing the WPA Key.

    Thanks

    JC
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice