1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

setup wizard cd included with linksys WAP54G

Discussion in 'General Discussion' started by Anonymous, May 11, 2005.

  1. Anonymous

    Anonymous Guest

    After entering the password admin, the software breaks down on an error and I cannot continue configuring my linksys access point. Also typing the IP address 192.168.1.245 in the internet explorer gives no response. Is there a new pc software available?
     
  2. howardp6

    howardp6 Network Guru Member

    The recommended setup of the WAP54G connects the access point to your network via the ethernet port on the unit to a your router or switch and using the Setup Wizard. Did you hook up the access point to your network? The latest firmware version is 2.08. There is no new setup software.
     
  3. Anonymous

    Anonymous Guest

    I get the same problem; start de cd , click next, enter default password 'admin' , then error message "access violation ...."
    Connect to 192.168.1.254 by browser, no response, ping to default ip adres; no responce.

    Does someone have a solution?
     
  4. Anonymous

    Anonymous Guest

    I had the same problem...the solution is to download the latest software from www.linksys.com for WAP54G, then the configuration utility worked as expected and (in my case) I could change the mode to "DHCP" for the accesspoint, after which I could surf into the web-config site with no problems!

    / Robert
     
  5. Anonymous

    Anonymous Guest

    for some reason i cant download the software from the site does anybody have it?
     
  6. mag82008

    mag82008 Guest

  7. scishark

    scishark Guest

    Nope that link is no good.
     
  8. jagboy

    jagboy Network Guru Member

    the link works for me
     
  9. Morpheus

    Morpheus Network Guru Member

    i will upload the CD now
     
  10. Morpheus

    Morpheus Network Guru Member

Share This Page