1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Shibby v111 - Power LED Problem

Discussion in 'Tomato Firmware' started by Cyberian75, Jul 28, 2013.

  1. Cyberian75

    Cyberian75 Network Guru Member

    Hey --

    The power LED turns itself off after a few minutes of booting up.

  2. Cyberian75

    Cyberian75 Network Guru Member

    Never mind, I see that it's related to Access Restrictions bug.
  3. shibby20

    shibby20 Network Guru Member

    you are right. :/ i will fix it and compile v111 one more time.

    on my router i have ipv6 but i dont use access restriction. on test router i checked access restriction and it worked fine but there i have ipv6...
  4. Cyberian75

    Cyberian75 Network Guru Member

    Thanks a lot. :)
  5. Cynsick

    Cynsick Addicted to LI Member

    Will it be announced when this new version is out, why not call it v111a? Does this require a compile for ALL versions or was this specific to just one?

Share This Page