Soldering Serial Port Onto WRT54G v2.0

Discussion in 'Cisco/Linksys Wireless Routers' started by BobCochran, Apr 22, 2005.

  1. BobCochran

    BobCochran Network Guru Member

    I'm thinking that since I want to take my WRT54G v2.0 access point board out of its stock enclosure and move it into a weatherproof enclosure meant for the outdoors, I might as well solder a serial port to it on the offchance that I might brick the unit at some time in the future and will then need to flash firmware in a hurry using tftp. It works fine now. Does this logic of adding-a-port-becuase-I-might-need-one-later make any sense?

    Is there a web page How-to complete with pictures showing how to solder a serial port onto a version 2,0 board? Including a list of parts I would need?

     
  2. jagboy

    jagboy Network Guru Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice