Some advice on wireless ethernet bridge

Discussion in 'Tomato Firmware' started by Snacks, Jul 29, 2008.

  1. Snacks

    Snacks Addicted to LI Member

    Hi guys,

    I'm having problems setting up my WRT54GL running tomato 1.21 as a wireless ethernet bridge. Can anyone point me in the direction of a tutorial or offer some advice in regards configuration required other than changing the wireless mode to "Wireless Ethernet Bridge"?

    And should I keep the IP of the bridge in the same subnet as my main router? or set it to something completely separate?
     
  2. Rob650

    Rob650 Addicted to LI Member

    Same subnet. If your main router is 192.168.1.1 set the bridge to 192.168.1.2. You can't use WPA2 in bridge mode.
     
  3. Snacks

    Snacks Addicted to LI Member

    That actually explains alot of the problems I've been having so far, thanks!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice