1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SPA9000 and RV016 w/Loadbalance

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by markn455, Dec 7, 2006.

  1. markn455

    markn455 LI Guru Member

    I just installed a second DSL line and connected to my RV016. Since that time, VoIP via my SPA9000 quit working. When I deactivate one of the DSL lines everything works again. So, I figued that I would use protocol binding to get around the problem. No luck. However it did work a little better. Then I tried to bind everythng on all ports to the IP address of my SPA9000. No luck.

    The RV016 protocol binding instructions are not very clear. Has anyone tried to do voip with a load balancing router?

    Mark
    Ball Ground, GA
     

Share This Page