1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SSH and Telnet Problems

Discussion in 'Tomato Firmware' started by burglar, Sep 23, 2007.

  1. burglar

    burglar Network Guru Member

    I was surprised because it is not working is Administration Access from Internet. First time I was test to start ssh shell from public WAN IP address, but without any success. The problem exist with web access and telnet too. I Enable all tree option in Firewall section: "Respond to Inbound Ping", "Allow Multicast" and "NAT Loopback"
    It's not problem with ISP, because owith other third part Firmwares is working! Last version(Tomato 1.0.7) of the firmware was updated in this section(Administration Access, added restriction IP addresses)maybe something was changed wrong. Can you give me a hint or some suggestion about this.


    Thanks!
     
  2. azeari

    azeari LI Guru Member

    make sure remote access is enabled for ssh and web admin under administration -> admin access. that ought to make it work.

    and ip address restrictions don't cause any probs here. tried and tested (= leaving it blank will equal no restrictions
     

Share This Page