STP not working with Linksys-routers w tomato

Discussion in 'Networking Issues' started by takas, Feb 17, 2014.

  1. takas

    takas Reformed Router Member

    Hi

    I need your help in this case.
    I have two Linksys e3000 and one e3200, all loaded with tomato by shibby v1.28.

    I wanted to setup a meshed network with these three units. Therefore I connected Router A to B, B to C and C to A. Prior to this I enabled STP, disabled WAN, switched to Router-mode and even edited the bridging-priority in CLI (brctl-command). But as soon as the loop was established, all port-LEDs began to flash and the network collapsed. After removing one link everything went fine.

    So there must be a wrong setting or the routers are unable to handle STP properly because these Linksys routers were never itended to be used in meshed networks.
    Any help appreciated!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice