Suggestion re: Backup Configuration

Discussion in 'Tomato Firmware' started by MacOfTheEast, Feb 25, 2007.

  1. MacOfTheEast

    MacOfTheEast LI Guru Member

    I think it would be a good idea if when using Tomato (v1.04) to backup it's configuration (Admin => Configuration => Backup Configuration) it only backed up those NVRAM registers that Tomato directly allows access to via its web interface. Currently it appears that it backs up all NVRAM registers much like executing 'NVRAM show' at the command prompt.

    I was hoping to Backup my current configuration, reset all NVRAM settings to factory defaults, and then restore from the backup but doing so restores NVRAM registers that I was trying to clear such as NC_GatewayName, NC_Homepage, snmpd_sysname, etc.

    MOTE
     
  2. GeeTek

    GeeTek Guest

    A check box giving the option would be the best way to enable this ability. I hate choosing only one or the other. This may also permit the ability to use the config file on routers other than the one that created the file.
     
  3. MacOfTheEast

    MacOfTheEast LI Guru Member

    I agree entirely! :) One option could be "Backup Tomato Settings" and the other could be "Dump NVRAM To File"

    Thank you, Mr. Tek
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice