1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Surveillance DVR and port forwarding help

Discussion in 'Tomato Firmware' started by LeonPhelps, Jul 31, 2008.

  1. LeonPhelps

    LeonPhelps Network Guru Member

    Hello,

    WRT54G here with Tomato 1.18. DHCP conection.

    I changed from DD-WRT to tomato.

    In DD-WRT I had this working fine. I could view my surveillance system easily with dyndns in IE. Basically I put in my dyndns IP and port http://xxx.dyndns.org:8081 and I could see my dvr fine.

    In DD-WRT I had port ranges forwarded for the necessary ports (8000-8008) Each had to be separately listed and were. I guess I need to know if I can put this in tomato and where.

    I also had in port forwarding the 8081 port directing to the IP of the system (192.168.x.x). This is obviously correct since my other dvr is working fine from the outside.

    Thanks for any help here.
     
  2. TheGIZ

    TheGIZ Network Guru Member

    8081 huh... looks like a post I wrote somewhere else...
    http://192.168.1.1/forward-basic.asp

    Write in where each port needs to be directed.
    aka:Springs in the world of remotes.
     
  3. baldrickturnip

    baldrickturnip LI Guru Member

    you have set the ports to be forwared in the port forwarding section listed at the side of the tomato screen ?
     

Share This Page