Telnet command for disconnect and connect?

Discussion in 'Linksys Official Firmware' started by Rudi1, Aug 4, 2006.

  1. Rudi1

    Rudi1 Network Guru Member

    Hi!

    Is it posible to connect to wrt54g- firmware 4.30.5 with telnet client and run connect and disconnect command?
    If is which one command I must use?

    thx!
     
  2. RonWessels

    RonWessels Network Guru Member

    The standard Linksys firmware does not enable a telnet server on the router, so you cannot telnet in. To enable telnet'ing to your router, you can run third-party firmware. I'd recommend investigating HyperWRT, DD-WRT and OpenWRT as possible candidates.
     
  3. Rudi1

    Rudi1 Network Guru Member

    I see,thx for your answer!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice