telnet connecting command

Discussion in 'General Discussion' started by Kris, Jun 14, 2009.

  1. Kris

    Kris Addicted to LI Member

    Hello.

    I have hmm maybe stupid question :redface:

    I want writing some script doing disconnect/connect (doing this router change IP - very useful on site like Rapidshare :rolleyes:).
    I usually use http control panel, but telnet script should be faster to use (only one click to reconnect :) )

    Everything is ok - but I don't know which command doing connect and disconnect :redface:

    "Reboot" command works fine :tongue: but it takes more time to start :frown:

    Linksys AG241
    Firmware Version: 7.01.04-Phoenix
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice